Smoke hollow WS30C Manual page 27

Operating Instructions
This smoker has 10 smoke program options that range from SP 0 to SP 9. Your smoker will
default to SP 4 (smoke program 4). If the desired smoke is not produced, this setting can be
changed. See Smoke Program Options.
7. Press the probe button
between probe 1 and probe 2 each time the button is pressed.
8. Once cooking is complete, press the on/off button
• Do not unplug the smoker at this time. The smoker is off, but the fan will continue to run for 5
minutes. This will prevent any burn back in the auger.
• Once the fan has automatically shut off, unplug smoker.
OPERATION
To help you develop an understanding of the smoke program, we have defined each setting below.
In addition, here are some key points to explain how this program works, and can be used, to master
your pellet smoking experience.
• The main reason for changing the SP setting is to adapt to your outside climate.
• Pellets will only produce heavy smoke when they are initially heated.
• The SP settings (SP 0 - SP 9) specify the auger cycle time during the smoke cycle. Based on our
testing, we have programmed your smoker to default to SP 4 for optimum smoke in most
climates.
• In a colder climate, the crucible will cool too much, causing the pellets from the previous cycle to
completely extinguish before igniting the fresh pellets. You need to decrease your SP setting for
more smoke.
• In a hotter climate, the crucible will not cool enough, allowing the fresh pellets to ignite quickly.
Therefore, minimal or no smoke is produced. You need to increase your SP setting for more
smoke.
SP Setting Table:
SP 0: Moves the pellets to the crucible for 15 seconds, then the auger rests for 45 seconds.
SP 1: Moves the pellets to the crucible for 15 seconds, then the auger rests for 55 seconds.
SP 2: Moves the pellets to the crucible for 15 seconds, then the auger rests for 65 seconds.
SP 3: Moves the pellets to the crucible for 15 seconds, then the auger rests for 75 seconds.
SP 4: Moves the pellets to the crucible for 15 seconds, then the auger rests for 85 seconds. (Default)
SP 5: Moves the pellets to the crucible for 15 seconds, then the auger rests for 95 seconds.
SP 6: Moves the pellets to the crucible for 15 seconds, then the auger rests for 105 seconds.
SP 7: Moves the pellets to the crucible for 15 seconds, then the auger rests for 115 seconds.
SP 8: Moves the pellets to the crucible for 15 seconds, then the auger rests for 125 seconds.
SP 9: Moves the pellets to the crucible for 15 seconds, then the auger rests for 135 seconds.
To change the SP (smoke program) setting:
1. Press the smoke button
2. Press the temperature button
3. Press the temperature button
to check internal food temperature. The indicator light will alternate
. You should see the letter "S" on the display screen.
. Using the up and down arrows
again. You have successfully changed the smoke program.
.
change the SP setting.
27