Table of Contents
Advertisement
V*AP
Set up GUI – INTERFACES – SDI I/O Interface – Status
This pane shows the status of the SDI interface (if one is installed) :
Video Standard
SDI Bypass
Relay Bypass
Test Generator Active
Video Delay Enabled
VANC Metadata
De-Embedder
VANC Metadata
Embedder
De-Embedder Audio Status
De-Embedder VANC
Metadata
ARIB B39
Data Available
Block Error
Audio Mode
Display of the video standard detected by the SDI input.
Turns yellow if the SDI bypass function is activated.
Turns yellow if the power fail relay is deactivated manually.
Turns yellow if the Generator is turned on.
Turns green if the video delay is activated.
Turns green if Dolby metadata is present in the input SDI stream.
Turns green if VANC embedder is enabled.
is grey if no audio is present.
Turns green if PCM audio is embedded.
Turns yellow if a non audio signal is present, an additional label shows
the kind of signal if it is possible to gather the information.
Shows which SDID was found and gives the operator an indication
which audio signals are related to that SDID.
See SMPTE 2020 for details.
Meta information standard
Turns green if ARIB B-39 meta information are detected.
Turns red if an error has been detected.
See ARIB Japanese standard "Structure of Inter-Stationary Control
Data Conveyed by Ancillary Data Packets"
http://www.arib.or.jp/english/html/overview/doc/2-STD-B39v1_2.pdf
25
Advertisement
Table of Contents
