After-Season Maintenance; Lubrication; Risks Present When Lubricating; Cutterbar - SaMASZ KDDR 861 Instruction Manual

6.7.2. After-season maintenance

At the end of the season clean, wash and dry the mower. Carefully grease unpainted surfaces
and 3-point linkage pins.
Moreover:
touch up the paintwork,

examine oil level in axis gears and cutterbar (item 7). If leaks are found remove them

immediately and refill the oil. If water in oil is found, immediately change the oil as it could
cause corrosion of internal mechanisms such as gear wheels, bearings, or shafts, and cause
breakdowns,
perform periodic checkups of the mower and protect all operating parts with grease in order to

prevent their baking and creating any sources of corrosion, which significantly influences
mower's proper operation,
check hydraulic hoses regularly. Replace any damaged or old hoses. Expiry period for hydraulic

hose should be no longer than 5 years from the date of manufactured marked on a hose.

7. LUBRICATION

7.1.

Risks present when lubricating

To avoid being splashed with pressurized liquid wear protective eyewear with side guards.

When lubricating protect skin against contact with the substance. Therefore use adequate long-

sleeved protective clothing and protective shoes. Use protective gloves, too. In case of a contact
with skin, immediately wash the infected area with plenty of soap water.
Do not allow the product to contaminate water outlets, water courses and soils.

In case of an unintentional release to the environment plug the leak, limit the spillage, and then

collect the oil with non-flammable absorbent material (e.g. sand).
The product is flammable. In case of fire, use adequate fire-extinguishing means (e.g. foam,

water mist, extinguishing powders). Do not use water jets.
Disposal of the used product must be made according to local regulations. Improper disposal of

the used oil poses danger to the environment.
7.2.

Cutterbar

Refilling oil in the cutterbar is done through the inlet A (Fig. 38a). Proper oil level is 5÷7 mm
from the cutterbar bottom. In order to drain oil from the cutterbar dismount the cutterbar enclosure
by releasing bolts (B) (Fig. 38b). Oil capacities are in.
Tab. 5. Oil capacities
Model
KDDR 861 (S/SL (H) (T)) - 8,60 m
KDDR 941 (S/SL (H) (T)) - 9,40 m
Operator's manual
Oil capacity [l]
2 x 6,0
2 x 6,5
- 40 -
Double-sided mower with central
suspension
"REWERS"
Oil type Orrication frequency
After first 50 h of operation, then
80W90 after next 500 h (or at least once
a year)