SaMASZ KDDR 861 Instruction Manual page 51

Calculating minimum weight of front ballast M

at rear and front:
Calculating minimum weight of rear ballast M

Calculating real axis load at tractor's front axis T

* If machine is mounted on tractor's front 3-point linkage (M
increase the weight of this machine to the required minimum load
Calculating total weight of tractor-machine assembly M

* If machine is mounted on tractor's rear 3-point linkage (M
increase the weight of this machine to the required minimum load
Calculating real axis load at tractor's rear axis T

Tyre load capacity – apply double the load indicated by the tyres' manufacturer.

ENTER THE ABOVE CALCULATION DATA AND TECHNICAL DATA PROVIDED BY
THE MANUFACTURER IN THE BELOW TABLE.
Minimum weight of
front or rear ballast
M or M
Pmin. Tmin.
Total weight
M
C
Front axis load
T
P rzecz .
Rear axis load
T
T rzecz.
Minimum ballast must be reached by mounting the machine or additional weights provided on the tractor.
Values resulting from calculations should be lower than or even to values given in technical specification.
Operator's manual
Real value from
calculations
≤
≤
≤
- 49 -
Double-sided mower with central
suspension
"REWERS"
– machine mounted at tractor's rear or
P min.
– machine mounted at tractor's front:
T min.
:
P rzecz .
) it is lighter than minimum required load at the front, so
P
:
C
) it is lighter than minimum required load at the rear, so
T
:
T rzecz.
Value to Double value of
technical
specification
≤
≤
tyre capacity
load