CAUTION:
The above instructions should be strictly followed. If the discs in
the cutterbar rotate loosely, do not worry about high intersecting axis gear
temperature; after long working time it may reach even 100
7.4.
Lubrication points
Every 50 hours of the mower's operation, lubricate its joints (Fig. 40) using STP grease.
Bearings (Fig. 41) on the mower should be lubricated using ŁT43 grease (or other equivalent
lubricant for rolling and sliding bearings which operate in temperature range of -30
Fig. 41. Point of lubrication with ŁT43 grease for non-locating bearing on conditioner shaft
Operator's manual
Lubrication
points
Fig. 40. Lubrication points to be lubricated with STP grease
Lubrication
point
Double-sided mower with central
- 42 -
suspension
"REWERS"
o
C.
o
C and +130
Lubrication
points
o
C.