Storing Of Machine - SaMASZ KDDR 861 Instruction Manual

reduce pressure using button

the tractor's hydraulics – for mowers with hydro-pneumatic unloading (KDDR H),
lift the machine so it is possible to insert support feet and secure them with cotters,

secure the tractor against free runaway,

dismount PTO shaft and place it on PTO shaft holder,

disconnect the machine's hydraulics and wiring system from the tractor,

disengage the machine from hangers of the tractor's lower links by lifting the three-point

linkage,
carefully drive the tractor away.


5.11. Storing of machine

Mower should be stored in dry places, secured against precipitation. If the mower is expose to
precipitation, maintenance work should be carried out during storing. In order to save storing
area e.g. under shed, houses, etc. the mower may be stored in vertical position (Fig. 28) but always
on paved surface. Storing the mower on an unpaved surface is inadmissible, for it may cause
the mower to lose stability and in consequence lead to falling for what the manufacturer shall not
bear any responsibility.
After storage period, before the machine is used:
check the mower's technical condition, and the transmission in particular,

supplement the paint where missing,

make sure that all nuts and screws are tightened properly,

make sure that all guards are in place,

protect all moving parts with grease in order to prevent their baking and creating any sources of

corrosion, which significantly influences mower's proper operation,
check oil level in axis gears and cutterbar. If leaks are found remove them immediately and

refill the oil. If water in oil is found, immediately change the oil as it could cause corrosion of
internal mechanisms such as gear wheels, bearings, or shafts, and cause breakdowns.
Operator's manual
on the control panel (Fig. 21), while reducing the pressure in
Fig. 28. Double-sided disc mower in its storing position
Double-sided mower with central
- 32 -
suspension
"REWERS"