How To Monitor External Ip Input Data; How To Monitor An External Ts Input Signal - R&S SMCVB-K167 User Manual

®
R&S SMCVB-K167

5.2.1 How to Monitor External IP Input Data

The R&S SMCV100B receives external IP input data as described in
"How to Apply an External IP Input
► Select "Input Signal > Info"
The "Info" side tab displays physical properties of the input IP stream data.
The standard packet length is 188 byte. The maximum useful data rate is specified by
the broadcast standard.
The measured data rate is lower and depends on the
data rate is lower than the measured data rate due to null packets present in the trans-
port stream.
If "Stuffing > On", the useful data rate can be lower than the maximum useful data rate.

5.2.2 How to Monitor an External TS Input Signal

The R&S SMCV100B receives external TS input data as described in
"How to Apply an External TS Input
► Select "Input Signal > Info"
User Manual 1179.1058.02 ─ 02
Performing DVB-S / DVB-S2 Signal Generation Tasks
Signal", on page 37.
Signal", on page 40.
Monitoring the Input Signal
Chapter 5.1.1,
TS source settings. The useful
Chapter 5.1.2,
42