R&S SMCVB-K167 User Manual page 28

®
R&S SMCVB-K167
1) For T2MI stream files, the data rate of a T2MI file is determined automatically, if the
following applies:
●
Data rate is not part of the TRP file header information.
●
PCR information is not available.
●
T2MI TRP file is not encrypted, that means not of type *.t2mi_c.
●
TRP file has the *.t2mi file extension.
Remote command:
:TSGen:CONFigure:PLAYfile
:TSGen:READ:PLAYfile:LENGth?
:TSGen:READ:FMEMory
Start [hh:mm:ss.fff]
Sets the start position in the loaded player file. Data which chronologically precedes
the start position is not replayed by the player.
The entered time stamp must chronologically always precede the entry under Stop.
Remote command:
:TSGen:CONFigure:SEEK:STARt
Position Player [hh:mm:ss.fff]
Displays the current play position in the file.
Remote command:
:TSGen:CONFigure:SEEK:POSition
Stop [hh:mm:ss.fff]
Sets the end position in the player file. Data which chronologically follows the end posi-
tion is not replayed by the player.
When the player reaches the "Stop" position, it returns to the "Start" position (continu-
ous play).
The entered time stamp must chronologically always follow the entry under Play.
Remote command:
:TSGen:CONFigure:SEEK:STOP
Reset Window
Resets "Start/Stop/Position Player" parameters.
Remote command:
:TSGen:CONFigure:SEEK:RESet
Play
Plays the selected file.
For supported file types, see
Remote command:
:TSGen:CONFigure:COMMand<ch>
Pause
Pauses the player.
After pausing, you can resume playing the file by clicking "Play" again.
User Manual 1179.1058.02 ─ 02
on page 59
on page 63
on page 62
on page 61
on page 60
on page 61
on page 61
Table 4-2.
on page 58
DVB-S Configuration and Settings
TS Player
28