Coding Settings - R&S SMCVB-K167 User Manual

®
R&S SMCVB-K167
If "Ping Result > Ping: Transmit Failed. xxx", the source address is not available in the
network. "xxx" can be, e.g. "General Failure". Try another "IGMPv3 Source Address".
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:RESult?
Local IP Data Network
Accesses local IP data network settings, see
tings",

4.3 Coding Settings

Access:
► Select "Baseband > DVB-S / DVB-S2 > Coding".
The tab provides settings for coding.
Settings:
Symbol
Constellation................................................................................................................. 22
Roll
Code
Symbol Rate
Sets the symbol rate.
In the transmission spectrum, the symbol rate represents the 3 dB bandwidth.
Remote command:
[:SOURce<hw>]:BB:DVBS:SYMBols
Constellation
Defines the constellation.
User Manual 1179.1058.02 ─ 02
on page 34.
Rate..................................................................................................................22
Off.......................................................................................................................... 23
Rate..................................................................................................................... 23
DVB-S Configuration and Settings
Chapter 4.7, "Local IP Data Network Set-
on page 55

Coding Settings

on page 53
22