Ip Channnel X Settings - R&S SMCVB-K167 User Manual

®
R&S SMCVB-K167
You can select a PRBS 15 or a PRBS 23 sequence as specified by
Remote command:
[:SOURce<hw>]:BB:DVBS:PRBS

4.2.4 IP Channnel x Settings

Access:
1. Select "Input Signal > General".
2. Select "Source > External"
3. Select "Input > IP"
4. Select "Input Signal > IP Channel x"
The tab provides settings necessary to configure IP channel x.
You can configure settings for 4 IP channels x = 1 to 4 individually, see also "Input
Signal > General > IP TS Channel".
IP channel settings affect input IP data of the local IP data network. The settings are
independent from the used broadcast standard configuration.
Saving/recalling a certain IP channel or local IP data network configuration is not possi-
ble via the broadcast standard-specific functionality.
Use the global save/recall functionality instead, see section "Saving and Recalling
Instrument Settings" in the R&S SMCV100B user manual.
The table below shows the availability of the tab in the broadcast standard configura-
tion.
User Manual 1179.1058.02 ─ 02
DVB-S Configuration and Settings
on page 50
Input Signal Settings
ITU-T O.151.
19