®
R&S
SMCVB-K167
5 Performing DVB-S / DVB-S2 Signal Gener-
ation Tasks
This chapter tells you how to configure the R&S SMCV100B to generate signals for
simple receiver tests.
●
Configuring the Input
●
Monitoring the Input
5.1 Configuring the Input Signal
This chapter provides an overview of the different input signals, that the
R&S SMCV100B uses as modulation data.
●
How to Apply an External IP Input
●
How to Apply an External TS Input
●
How to Generate an Internal TS
5.1.1 How to Apply an External IP Input Signal
To connect the R&S SMCV100B to local IP data network
1. Connect the IP source to the "IP Data" connector of the R&S SMCV100B.
See chapter "Connecting to IP Data Interface" in the R&S SMCV100B Getting Star-
ted user manual.
2. Select "Input Signal > General > Source > External".
3. Select "Input Signal > General > Input > IP".
4. In the "IP Channel x" side tab, click "Local IP Data Network".
By default, the R&S SMCV100B assigns the IP address automatically using
("Address Mode > Auto (DHCP)").
5. If "Network Status > Disconnected", try "Restart Network".
User Manual 1179.1058.02 ─ 02
Performing DVB-S / DVB-S2 Signal Generation Tasks
Signal....................................................................................37
Signal..................................................................................... 41
Signal............................................................... 37
Signal.............................................................. 40
Signal.................................................................. 41
Configuring the Input Signal
DHCP
37