R&S SMCVB-K167 User Manual page 21

®
R&S SMCVB-K167
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:ALIas
Type
Sets the input signal type.
"Unicast"
"Multicast"
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:TYPE
Multicast Address
Editing requires "Type > Multicast".
Sets the destination IP address (IPv4) of the IP connection.
You can set addresses from "224.0.0.0" to "239.255.255.255".
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:MULticast:ADDRess
Port
Sets the destination UDP port.
Due to
between neighboring IP TS channels.
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:PORT
IGMPv3 Source Address
Requires "Type > Multicast".
Sets the
If you need to filter the data sent to the multicast address, specify the source address.
A source address different from "0.0.0.0" accepts only data originating from the speci-
fied IP address.
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:ADDRess
Ping Source Address
Clicking "Ping Source Address" triggers pinging of the IGMPv3 source address.
If you set a different value from "IGMPv3 Source Address = 0.0.0.0" and click the but-
ton, the software checks if the address is reachable.
Remote command:
[:SOURce<hw>]:BB:INPut:IP<ch>:IGMP[:SOURce]:PING
Ping Result
Displays the result after pinging the source address.
If "Ping Result > Ping: Successful", the source address is available in the network.
User Manual 1179.1058.02 ─ 02
Analyzes all unicast IP packets that arrive at the specified "Port".
When an IP address is in the multicast address range, an attempt is
made to join a multicast group using IGMP.
Set "Multicast Address" and "Port".
UDP/RTP autosensing, we recommend that you set a port offset of at least 6
IGMPv3 source address.
DVB-S Configuration and Settings
Input Signal Settings
on page 52
on page 52
on page 53
on page 52
on page 53
on page 53
21