®
R&S
SMCVB-K167
4.7 Local IP Data Network Settings
Access:
1. Select "Input Signal > General > Source > External".
2. Select "Input Signal > General > Input > IP"
3. Select "Input Signal > IP Channel x > Local IP Data Network".
The tab provides access to local IP data settings necessary to configure the board
address.
The remote commands necessary to configure local IP data network settings are
described in
How to:
Settings:
Network
Hostname......................................................................................................................35
Address.....................................................................................................................35
Protocol......................................................................................................................... 36
Network Status
Indicates that the instrument is connected to the network.
If the instrument is disconnected, try "Restart Network".
Remote command:
:SYSTem:COMMunicate:BCIP<hw>:NETWork:STATus
User Manual 1179.1058.02 ─ 02
Chapter 6.6, "BCIP
Chapter 5.1.1, "How to Apply an External IP Input
Status..............................................................................................................34
Network............................................................................................................ 35
Mode............................................................................................................... 35
Mask................................................................................................................. 36
Connector............................................................................................................36
Address................................................................................................................ 36
DVB-S Configuration and Settings
Local IP Data Network Settings
Subsystem",
on page 63.
Signal",
on page 37
on page 66
34