R&S SMCVB-K167 User Manual page 14

®
R&S SMCVB-K167
"External"
"Test Signal"
Remote command:
[:SOURce<hw>]:BB:DVBS:SOURce
Input
Requires "Source > External".
Sets the external input interface.
"TS IN"
"IP"
Remote command:
[:SOURce<hw>]:BB:DVBS:INPut
Input Format
Requires "Input > TS IN".
Sets the format of the input signal.
"ASI"
"SMPTE 310"
Remote command:
[:SOURce<hw>]:BB:DVBS:INPut:FORMat
IP TS Channel
Requires "Input > IP".
Selects the IP-based transport stream (TS) channel. You can select 1 out of 4 IP TS
channels as input at the "IP Data" interface.
To configure a particular channel, see
on page 19.
Remote command:
[:SOURce<hw>]:BB:DVBS:INPut:TSCHannel
User Manual 1179.1058.02 ─ 02
Uses a transport stream, that is input at the "TS IN"/"IP Data" inter-
face.
For more information about connecting to the interfaces, see also:
●
"TS IN" interface: Section "Configuring the Global Connectors" in
the R&S SMCV100B user manual.
●
"IP Data" interface:
tings", on page 34.
Uses an internal transport stream with TS packet data played from a
file. The player requires no option.
Playing encrypted files with extension _c requires a stream library
option R&S SMCVB-KSx.
See also:
●
Chapter 4.6, "TS Player",
●
Supported TS player file types
Uses an internal test signal as specified in
Settings", on page 17.
on page 47
Input for serial transport stream data. The signal is input at the "User
1" connector.
Input for IP-based transport stream data (TSoverIP). The signal is
input at the "IP Data" connector.
on page 47
ASI format
SMPTE 310 format
Chapter 4.2.4, "IP Channnel x
DVB-S Configuration and Settings
Chapter 4.7, "Local IP Data Network Set-
on page 25
Chapter 4.2.3, "Test Signal
on page 47
on page 47
Input Signal Settings
Settings",
14