JRC JLZ-1000 Instruction Manual page 52

Connecting a video signal cable
VIDEO
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Pin No.
1 Red
2 Green
3 Blue
4 Unused
5 GND
6 GND
7 GND
8 GND
9 Unused
10 GND
11 Unused
12
13 Horizontal
synchronous
14 Vertical
synchronous
15 Unused
Fix a video signal cable by firmly tightening both sides of the connector.
Note
If the cable moves due to vibrations, the connector and cable are stressed. Since this may result in
disconnection of the cable, firmly fix the cable with a clamping band.
At the factory delivery, the monitor resolution is set to XGA (1024 x 768 pixel). When changing the
resolution to SVGA (800 x 600 pixel), refer to the following page.
Section 3 Installation
Name
RED Outputs a video red signal
GRN Outputs a green video signal
BLU Outputs a blue video signal
HSYNC Outputs a horizontal synchronous signal
VSYNC Outputs a vertical synchronous signal
3-10
Description