Table of Contents
Advertisement
Item
GPS
Set DGPS
Magnetic
Enabled
Variation
Value
Section 8 System Configuration Menus
Mode
Set a frequency baud rate of the
beacon automatically or manually.
Frequency
Set a frequency when [Mode] is set
to [Manual].
Baud rate
Set a baud rate when [Mode] is set
to [Manual].
Correction
Set a DGPS correction mode.
mode
Set data
This item is executed when DGPS is
changed.
When this item is executed, the set
command is transmitted to the
DGPS receiver.
Set whether to enable the variation
of the magnetic bearing.
When a check mark is attached, this
item is enabled and when the check
mark is removed, this item is
disabled.
Set a variation amount.
Setting a variation amount:
Select a digit to be set by using the
value by using the
(Up/Down) keys, and confirm the
change by using the
key. To switch between 'W' and
'E, press the
(Zoom Out) keys.
8-16
Setting Contents
(Left/Right) keys, change the
(Center) or
(Zoom In)/
Setting value
(Underline:
Default value)
Auto
Manual
280.0KHz to
310.0 to
330.0KHz
50 bps
100 bps
200 bps
Beacon
SBAS
Auto
-
Enable
Disable
99.9'W to
00.0'E to
99.9'E
Advertisement
Table of Contents
