Table of Contents
Advertisement
Item
NMEA0183
NMEA /
-Port2
JRC
NMEA0183
out
NMEA0183
speed
NMEA out
version
NMEA0183
data
NMEA2000
NMEA2000
out
NMEA2000
PGN
Power
Data view
Section 8 System Configuration Menus
Setting Contents
Select a format of the signals that are transmitted
and received.
Select a data output interval.
To suppress output of signals from the NMEA port
2, select [Off].
Select an output speed (Baud rate) from
NMEA0183 port 2.
Select a version of the sentence that is output from
NMEA0183 port 2.
Select a sentence that is output from NMEA0183
port 2.
Set for the following sentences.
APA/APB/BWR/GGA/GLL/GSA/GSV/RMB/RMC/
VTG/XTE/DBT/DPT/VHW/MTW/ZDA/HDT
When a check mark is attached, this item is
enabled and when the check mark is removed, this
item is disabled.
Set whether data is output from the NMEA2000
port. .
When a check mark is attached, this item is
enabled and when the check mark is removed, this
item is disabled.
Select PGN that is output from NMEA2000.
The following PGN are available for setting.
Water Speed (128259) / Water depth (128267) /
XTE (129283) / NAV. data (129284) /
NAV. data (129285) / COG & SOG (129026) /
GNSS position (129029) / Water temp. (130310)
When a check mark is attached, this item is
enabled and when the check mark is removed, this
item is disabled.
Set whether power is output from the NMEA2000
port.
When a check mark is attached, this item is
enabled and when the check mark is removed, this
item is disabled.
Displays the data that is received from the
selected port.
8-20
Setting value
(Underline:
Default value)
NMEA
JRC
Off/1sec/2sec/
3sec/4sec/5sec
4800
38400
Version 1.5
Version 2.1
Version 2.3
Version 4.0
<Default value>
Disable all
Enable
Disable
<Default value>
Disable all
Enable
Disable
GPS
NMEA0183-1
NMEA0183-2
NMEA2000
Advertisement
Table of Contents
