Table of Contents
Advertisement
Item
Navigation
alarms
Danger
AIS
Dangerous vessel
ARPA(TT)
Dangerous vessel
DGPS
Restore default
Setting Contents
Value
Set a route width.
Enabled
Set whether to issue an alarm when a
monitoring area is set around
waypoints and own ship enters in the
monitoring area.
When a check mark is attached, this
item is enabled and when the check
mark is removed, this item is disabled.
Value
Set a radius of the monitoring area
when [Operation] is enabled.
Setting a radius
Select a digit to be set by using the
(Left/Right) keys, change the
value by using the
keys, and confirm the change by using
the
(Center) or
Set whether to issue an alarm when a
'Dangerous vessel' situation occurs.
When a check mark is attached, this
item is enabled and when the check
mark is removed, this item is disabled.
Set whether to issue an alarm when a
'Dangerous vessel' situation occurs.
When a check mark is attached, this
item is enabled and when the check
mark is removed, this item is disabled.
Set whether to issue an alarm when
differential positioning is disabled.
When a check mark is attached, this
item is enabled and when the check
mark is removed, this item is disabled.
Reset the setting values of the alarm
menu to the default values.
To reset, select [Yes].
To cancel reset, select [No].
8-31
Setting value
(Underline: Default
value)
0.01/0.02/0.03/0.04/
0.05/0.06/0.07/0.08/
0.09/0.10/0.20/0.30/
0.40/0.50/1.00/2.00/
5.00nm
Enable
Disable
0.00nm to 1.00nm to
9.99nm
(Up/Down)
key.
Enable
Disable
Enable
Disable
Enable
Disable
Yes, No
Section 8 System Configuration Menus
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
Advertisement
Table of Contents
