Table of Contents
Advertisement
Item
Navigation
Waypoint
alarms
alarm
Anchor
alarm
XTE
alarm
Section 8 System Configuration Menus
Setting Contents
Enabled
Set if an alarm is to be issued when
own ship enters in or deviates from the
arrival circle range during route
navigation.
Off: An alarm is not issued.
Arrival: An alarm is issued when own
ship enters in the arrival circle range.
Deviation: An alarm is issued when
own ship deviates from the arrival
circle range.
Value
Set a radius of the arrival circle when
[Operation] is set to [Arrival] or
[Deviation].
Setting a radius
Select a digit to be set by using the
(Left/Right) keys, change the
value by using the
keys, and confirm the change by using
the
(Center) or
Enabled
Set if an alarm is to be issued when a
circle monitoring area is set around
own ship and own ship exits from the
monitoring area.
When a check mark is attached, this
item is enabled and when the check
mark is removed, this item is disabled.
Value
Set a radius of the monitoring area
when [Operation] is enabled.
Setting a radius
Select a digit to be set by using the
(Left/Right) keys, change the
value by using the
keys, and confirm the change by using
the
(Center) or
Enabled
Set whether to issue an alarm when
own ship enters in or deviates from the
route width during route navigation.
Off: An alarm is not issued.
Deviation: An alarm is issued when
own ship deviates from the route width.
Entry: An alarm is issued when own
ship enters in the route width.
8-30
Setting value
(Underline: Default
Off
Arrival
Deviation
0.01nm to 0.05nm to
9.99nm
(Up/Down)
key.
Disable
Enable
0.00nm to 0.02nm to
9.99nm
(Up/Down)
key.
Off
Deviation
Entry
value)
Advertisement
Table of Contents
