Table of Contents
Advertisement
Item
Distance
User line drawing
User line display
Find
Waypoints
Routes
AIS
vessels
Ports by name
Tide station
Section 7 Function Menus
Measure the distance and bearing from any
reference point to any point on the map.
Set the cursor to the reference point, press the
(Center) or
to any point by using the trackball or the
The distance and bearing from the reference
point to the specified point are displayed at the
bottom left corner of the screen.
To end the operation, press the
Switch to a line drawing mode.
See Section 5.6 "Drawing lines".
Set the graphics and characters that are
created in plotting mode to display or
undisplay.
When a check mark is attached, the item is
enabled (display) and when the check mark is
removed, the item is disabled (undisplay).
Search a mark that is registered.
When a mark to be searched is selected from
the mark list that is displayed and the selection
is confirmed, the mark is displayed at the
center of the map.
Search a route that is set.
When a route to be searched is selected from
the route list that is displayed and the selection
is confirmed, the first waypoint of the route is
displayed at the center of the map.
By MMSI
Search other ship (AIS target) with its MMSI
(identification number).
When MMSI to be searched is selected from
the MMSI list that is displayed and the
selection is confirmed, the position of the AIS
target is displayed at the center of the map.
By Name
Search other ship (AIS target) with the name.
When a name to be searched is selected from
the name list that is displayed and the
selection is confirmed, the position of the AIS
target is displayed at the center of the map.
Search a port.
When a port name to be searched is selected
from the port name list that is displayed and
the selection is confirmed, the position of the
port of the search target is displayed at the
center of the map.
To end the operation, press the
Search a tide information forecast point.
When a point to be searched from the point list
that is displayed and the selection is
confirmed, the search target point is displayed
at the center of the map.
Setting contents
key, and move the cursor
(Up/Down/Left/Right) keys.
7-4
Setting value
(Underline:
Default value)
-
key.
-
Enable
Disable
-
-
-
-
-
key.
-
Advertisement
Table of Contents
