Table of Contents
Advertisement
27
3.6
SCPI Commands for the ADTS 2XX
Through the RS232 serial interface the ADTS 2XX can be remotely controlled from a PC. The ADTS 2XX receives
commands and queries, it responds by changing operating modes and conditions and by sending
information on status and pressure readings. The communications parameters for the RS232 interface can
be configured in the set-up menu and are based on typical SCPI syntax. The PC communications cable (item
5, Table 2-1) should be used for connection between the PC and the ADTS 2XX (see Figure 2-4).
External Control using RS232 Communications
SCPI Commands
This section describes each command and query in detail including parameters used and response data
returned. The general short form command is shown at the top of each page. The following information
given:
Command Syntax
Parameter Type
Parameter Range
Units
Password
Function
Conditions
Query Syntax
Parameter Type
Parameter Range
Returned Data
Returned Data Type
Returned Data Range
Units
Function
Conditions
Commands to ADTS 205
All SCPI commands must be terminated with 0A Hex
Command Responses from ADTS 2XX
All responses from the ADTS 2XX terminate with 0A Hex.
-
The upper case represents the short form command.
-
REAL, INTEGER, DISCRETE or STRING
-
Either the range of INTEGER/REAL numbers or the choice of DISCRETE or
maximum STRING length.
-
The units used for some specified parameters.
-
Password protects some commands; software version 4.30 onwards.
-
Basic function of the command, see user manual for full description of the
function.
-
Any condition that limits the use of a command.
-
Syntax of query command includes parameters passed as part of the
query.
-
As for command (above).
-
As for command (above).
-
Data returned by the ADTS following a query command.
-
As parameter type.
-
As parameter range.
-
Units of returned data.
-
Basic function of query command.
-
As for command.
Druck ADTS 2XX User Manual
K0451 Issue No. 1
Advertisement
Table of Contents
