Command And Query Summary; Command Structure; Common Scpi Commands - Three Letter Commands, Prefixed By; Instrument Control Commands - Three Letter Commands, Prefixed By - GE PACE Series Technical Manual

PACE Series SCPI Manual
4

COMMAND AND QUERY SUMMARY

The following lists of all the SCPI commands and queries that apply to the instrument.
4.1

Command Structure

Some of the commands in the following summary are enabled at specific times and
conditions, most can be enabled at any time. The command structure divides into
subsystems as follows:
Command sub-system
:CALibration - calibration commands.
:DIAGnostic - instrument generated condition data.
INPut - switch input of the control module.
:INSTrument - instrument specific commands.
:OUTPut - controls the output pressure and logical outputs.
:SENSe - directs the instrument to measure selected parameters.
:SOURce - the commands that control the pressure outputs.
:STATus - instrument state.
:SYSTem - errors and SCPI version.
:UNIT - sets the units for the instrument.

Common SCPI commands - three letter commands, prefixed by *.

Instrument control commands - three letter commands, prefixed by :.

K0472 Revision A 4-1