Display Settings; Fig. 3.14 Brightness Setting Display; Fig. 3.15 Contrast Setting Display - R&S 4200 Series Operating Manual

R&S XU 4200
3.4.3.5

Display Settings

Introduction
Brightness setting
Contrast setting
6166.5368.02.01
It is possible to set up brightness and contrast anywhere in the menu by
pressing the cursor keys.
1. Press the ► or ◄ cursor keys for approximately one second.
A setting window (brightness or contrast) with a shifter appears.
2. Use the ▼ or ▲ cursor keys to select the brightness window.
X U 4 2 0 0
M U B r i g h t n e s s
1
-- -- -- -- -- -- -- -- -- --
II
C B I T - S T A T U S
Fig. 3.14 Brightness setting display.
3. Use the ► or ◄ cursor keys to change the setting.
The cursor will move to the right, or left and luminance of the display
will intensify, or reduce accordingly.
4. Press the ENTER key or wait approximately three seconds until the
window disappears.
5. Press the ► or ◄ cursor keys for approximately one second.
A setting window (brightness or contrast) with a shifter appears.
6. Use the ▼ or ▲ cursor keys to select the contrast window.
X U 4 2 0 0
M U C o n t r a s t
1
II -- -- -- -- -- I -- -- -- -- --
C B I T - S T A T U S
Fig. 3.15 Contrast setting display.
7. Use the ► or ◄ cursor keys to change the setting.
The cursor will move to the right, or left and the contrast of the display
will intensify, or reduce accordingly.
8. Press the ENTER key or wait approximately three seconds until the
window disappears.
Note: The settings will be stored temporarily if there is no key operation for
5 seconds. If the settings are not stored manually, the old values will be
recovered after the reboot.
Local Control (Local Mode)
2 1 : 0 4 : 1 3
I II
1 0 0 %
2 1 : 0 4 : 1 3
5 0 %
3.34
1 7
A M
O K
1 7
A M
II
O K