Limitations/Notes; Voip Information On Standard Operation Screen - R&S 4200 Series Operating Manual

Audio via VoIP (Optional)
3.15.4

Limitations/Notes

Limitations
3.15.5

VoIP Information on Standard Operation Screen

Introduction
Please note that there are certain limitations to radio operation if the VoIP
interface is active:
 Voice transmission is in AM mode. The ACARS and VDL Mode 2
modes are not supported
 Parameter "Audio Delay" is not applicable to VoIP interface

Configuration parameter "True Sidetone Transceiver" should be left in
the default state (Enabled). If disabled, the receiver is muted while the
transceiver is transmitting
This chapter describes behavior on the standard operation screen while the
radio is running in VoIP mode.
The standard operation screen informs the user about active SIP sessions
of the radio. This information contains the number of active SIP sessions for
the RX (0) and TX (1) module.
The information of active SIP sessions replaces the information
"ACT/INACT" on the standard operation screen.
X U 4 2 0 0
L O C A T I O N
1 1 9 1 2 5
.
L O C S I P 0 / 1
C B I T S T A T U S :
The number directly following "SIP" indicates the number of active SIP
sessions on the RX module. The number following the slash sign indicates
active SIP sessions on the TX module. If both modules manage active SIP
sessions, the standard operation screen summarises them.
X U 4 2 0 0
L O C A T I O N
1 1 9 1 2 5
.
L O C S I P
C B I T S T A T U S :
3.107
2 1 : 0 4 : 1 3
I N F O
+ 0 . 0
2 1 : 0 4 : 1 3
I N F O
+ 0 . 0
2
R&S XU 4200
A M
O K
A M
O K
6166.5368.02.01