Cbit Type Configuration; Local Control (Local Mode) - R&S 4200 Series Operating Manual

Local Control (Local Mode)

3.3.3

CBIT Type Configuration

Function
CBIT type configuration\CBIT type configuration "Radio".doc
DC-Battery Supervision
AC-Main Supervision
External VSWR Warning
Local Mode Warning
USB Connect Warning
Inactive Warning
User Contact Warning
TX Power Low Warning
PSU Fan Warning
VSWR Warning
Main Fan Warning
E1 LOS
E1 LOF
E1 RAI Warning
E1 CRC4 ERROR Warning
Preset Pages Configuration\Preset Pages Configuration "Radio".doc
3.4 Local Control (Local Mode)
Local Control\Local Control "Radio".doc
The CBIT parameters can be configured as shown in the table below.
Disabled
Note: If the radio is set to local mode (LOC), remote control commands will
be refused. Local mode has the highest priority and interrupts any remote
control fixed sessions. Parameters can only be monitored remotely when
the radio is in local mode.
When the radio is in the local mode, you can connect a headset and power
up the transmitter by pressing the PTT key at any time.
In the receive mode, the front-panel receive audio signal is always audible.
In other words, the internal loudspeaker and the headset audio connector
are always active and the volume of the two can be controlled by the
assigned potentiometer.
Note: The local mode causes the termination of all active VoIP connections
if the parameter "Line Interface in Local" mode is disabled. As long as the
radio is in local mode, all VoIP connection requests are rejected.
All parameters and measurements can be displayed in the remote and local
modes.
Warning
X X
X X
X X
X X
X X
X X
X X
X
X
X
X
X
X
X
X
3.25
R&S XU 4200
NOGO
X
X
X
X
X
X
X
X
X
X
X
6166.5368.02.01