Introduction/Overview; Cabling; Configuration; Radio In Vdl Mode - R&S 4200 Series Operating Manual

R&S XU 4200
3.14

Radio in VDL Mode 2

VDL2 Mode\VDL2 Mode "Radio".doc
This chapter
3.14.1

Introduction/Overview

Introduction
3.14.2

Cabling

Instructions
Cabling
3.14.3

Configuration

General
VDL Mode 2
configuration using
the R&S ZS 4200
6166.5368.02.01
This chapter provides information about the cabling and configuration of
digital data mode (VDL Mode 2).
The radio supports the VDL Mode 2 in the transceiver configuration. A VDL
ground computer (VGC) is connected to the radio via the LAN port. The
VGC is always connected to the LAN port of the receiver module of the
transceiver.
1. Connect the radio via the connectors X6 and X9 to the LAN network.
Transceiver
X9
LAN to
VGC
(VDL +
Remote
Control)
Fig. 3.91 VDL Mode 2 cabling.
The VDL Mode 2 activation on the radio can be done using the MMI or via
the remote control.
1. Use the Service and Maintenance Tool R&S ZS 4200 to set the
modulation to "VDL Mode 2" in at least one preset page.
Note: The operation of the Service and Maintenance Tool R&S ZS 4200 is
described in detail in the corresponding operating manual.
Note: Activation of VDL Mode 2 is only possible if the configuration
parameter "Select Audio Interface" has been set to "Analog Audio" by
using the Service and Maintenance Tool R&S ZS 4200.
3.102
Radio in VDL Mode 2
X6
LAN