Cabling; Configuration; Fig. 3.88 Radio Operation Via E1 Interface - R&S 4200 Series Operating Manual

Audio via E1 Interface (Optional)
3.12.2

Cabling

Instructions
Cabling
3.12.3

Configuration

E1 interface
configuration using
the R&S ZS 4200
1. Connect the transceiver to the E1 transmission network via connector
X13 (receiver module) only.
Radio
X13
RX1_RING 2
RX1_TIP 3
TX1_RING 5
TX1_TIP 6
GND
4, 7
Fig. 3.88
Note: See chapter 6.2 for additional information about the E1 interface.
Use the Service and Maintenance Tool R&S ZS 4200 to configure the E1
interface.
1. Set the "Select Audio Interface" parameter on the radio to "E1".
2. Configure the "TX Audio ALC E1" and adjust the "TX Audio Level E1"
as required in your E1 audio infrastructure.
3. Configure the "RX Audio AGC E1" and adjust the "RX Audio Level E1"
as required in your E1 audio infrastructure.
4. Set the "E1 RAI Warning" and "E1 CRC4 ERROR Warning" parameters
as necessary for your redundancy configuration.
5. Set the "Alarm for Inactive Warning" parameter as necessary for your
redundancy configuration.
E1
Transmission
MUX
Network
Radio operation via E1 interface.
3.95
R&S XU 4200
VCS
6166.5368.02.01