Cabling; Configuration; Fig. 3.94 Voip Cabling - R&S 4200 Series Operating Manual

R&S XU 4200
3.15.2

Cabling

Instructions
Cabling
3.15.3

Configuration

VoIP interface
configuration using
the R&S ZS 4200
6166.5368.02.01
Connect the radio via the connectors X6 and X9 to the LAN network.
1.
Transceiver
LAN
VoIP +
X9
(Remote
Control)
Fig. 3.94 VoIP cabling.
Use the Service and Maintenance Tool R&S ZS 4200 to configure the VoIP
interface.
Set the "Select Audio Interface" parameter on the radio to "VoIP".
1.
Configure the "VoIP radio URI TX".
2.
Configure the "VoIP radio URI RX".
3.
Configure the "Emergency VoIP URI ACL".
4.
Configure the "Normal VoIP URI ACL".
5.
Configure the "TX Audio ALC VoIP" and adjust the
6.
"TX Audio Level VoIP" as required in your VoIP audio infrastructure.
Note: The default settings (see chapter 3.3.1) ensures the compliance with
the ED-137 requirement of 30 % AM modulation depth at −10 dBm0 audio
level. If the VoIP infrastructure complies with the ED-137, the default value
shall be left unchanged.
Configure the "VoIP PTT Summation Mode".
7.
Configure the "VoIP Jitter Buffer Prefetch Value".
8.
Configure the "RX Audio AGC VoIP" and adjust the
9.
"RX Audio Level VoIP" as required in your VoIP audio infrastructure.
Note: The default settings (see chapter 3.3.1) ensures the compliance
with the ED-137 requirement of −10 dBm0 at 30% AM modulation depth. If
the VoIP infrastructure complies with the ED-137, the default value shall be
left unchanged.
3.106
Audio via VoIP (Optional)
LAN
VoIP +
X6
(Remote
Control)