Configuration; Limitations/Notes; R&S External Automatic Filter - R&S 4200 Series Operating Manual

R&S XU 4200
3.7.1.3

Configuration

Setting using
the R&S ZS 4200
3.7.1.4

Limitations/Notes

Limitations
3.7.2 R&S External Automatic Filter
This chapter
3.7.2.1 Introduction/Overview
Introduction
6166.5368.02.01
Use the Service and Maintenance Tool R&S ZS 4200 to activate the Telsa
external automatic filter.
1. Set the "Motor Tuned Telsa Filter" parameter to "Enable" on the radio.
Note: The operation of the Service and Maintenance Tool R&S ZS 4200 is
described in detail in the corresponding operating manual.
Please note that there are certain limitations to radio operation if a Telsa
Automatic Cavity Filter is used:
 Enabling the Telsa external automatic filter will reduce the frequency
range. Please refer to the specification of the filter
Note: If more than one radio is used, each radio needs its separate filter.
Note: The timeout for tuning the filter is set to 60 seconds. If the filter has
not tuned to the correct setting by this time, the radio will generate a CBIT
warning.
This chapter provides information about cabling and configuration using the
R&S external automatic filter R&S®Fx22x together with the radio.
The radio directly supports serial control of Telsa Automatic Cavity Filters.
With help of R&S®KG42-Z75 X-cross adapter the R&S®Fx22x automatic
filters can be used together with the R&S®Series4200 radios.
The R&S external automatic filter is optional hardware equipment and it is
not contained in a standard shipment.
External Automatic Filters
3.80