Preparation For Use; Safety Precautions - R&S 4200 Series Operating Manual

Safety Precautions

2

Preparation for Use

This chapter
Further
information
2.1 Safety Precautions
Safety Precautions\Safety Precautions"Radio".doc
ATTENTION
ATTENTION
This chapter provides all information for:
 Checking upon delivery
 Installation into a 19" rack
 Connection of peripheral equipment
 Connection of mains and/or 28 V DC supply
Chapter 3.1 contains an overview of the transceiver control elements,
indicators, etc.
Chapter 6.2 is an in-depth description of the radio's interfaces.
Before putting the transceiver into operation, make the following checks:
 Ensure that the ventilation holes are free of obstructions.
 Ensure that there are no unsuitable signal voltages connected to the
input.
 The transceiver's outputs may not be overloaded and correct polarity
must be ensured.
The radio may be damaged if the above checks are not performed.
When fitting operating rooms and installing and operating electrical
equipment, the relevant national and international safety provisions and
regulations have to be adhered to.
The following safety instructions apply in particular:
IEC 364

 VDE 0100
 DIN 57100
These safety regulations deal with the following subjects:
 Protective measures:
- Prevention of accidents
- Overvoltage protection
- Insulation of equipment
- Grounding
 Type and laying of lines and cables
Provisions for operational facilities, rooms and equipment requiring

special handling
Note: Electrostatic discharge (ESD) can cause temporary malfunctioning of
the display, resulting in the deletion of the on-screen contents. This
malfunction can be eliminated by restarting the radio. ESD discharges will
not impair other functional features of the radio.
2.1
R&S XU 4200
6166.5368.02.01