Limitations/Notes; Parallel Operation Of The Analog And E1 Audio Interfaces - R&S 4200 Series Operating Manual

R&S XU 4200
3.12.4

Limitations/Notes

Limitations
3.12.5

Parallel Operation of the Analog and E1 Audio Interfaces

Introduction
TX Audio Basic
interface X5
RX Audio Basic
interface X10
0.
6166.5368.02.01
Please note that there are certain limitations to radio operation if the E1
interface is active:
 Voice transmission is in AM mode. The ACARS and VDL Mode 2
modes are not supported
 Parameter "Audio Delay" is not applicable to E1 interface
 Parameter "Line Interface in Local Mode" is not applicable to E1
interface of the RX module. Audio over E1 interface is not muted in
Local Mode when the parameter is disabled
Analog interface functionality remains unchanged when E1 audio interface
is selected (see chapter 3.3).
Radio functionality related to the TX Audio Basic interface X5 remains
unchanged when E1 audio interface is selected. Transmitter can be keyed
via E1 interface or using the rear PTT input (connector X5.8/X5.9).
In-Band PTT can be configured on the X5 interface as well (see chapter 3.8
In-Band Signaling).
Note: Analog transmitting via the X5 and E1 cannot work simultaneously.
Only one PTT and audio source are accepted at a time.
Radio functionality related to the RX Audio Basic interface X10 remains
unchanged when the E1 audio interface is selected. The received
demodulated audio signal is available on the Analog and E1 interfaces in
parallel.
Note: When in-band signalling is enabled (SQ or RSSI, see chapter 3.8
In-Band Signaling), the tones are present only on the RX Audio Basic
interface X10.
Audio via E1 Interface (Optional)
3.96