Configuring With The R&S Zs 4200; Factory Default Settings - R&S 4200 Series Operating Manual

Configuring with the R&S ZS 4200
3.3 Configuring with the R&S ZS 4200
Configuring\\Configuring "Name".doc
Introduction
3.3.1

Factory Default Settings

Switching on
for the first time
Switching on
in general
Changing the radio
parameters
Properties
Default setting\Default setting "Radio".doc
Parameters
TX Audio Level
RX Audio Level
TX Output Power Level Low
TX Output Power Level
Normal
S/N Squelch Threshold
RSSI Squelch Threshold
Carrier Override
The transceiver is equipped with LAN and USB interfaces to allow
communication with the Service and Maintenance Tool R&S ZS 4200.
The following activities can be carried out:
 Software download
 Preset setup
 Configuration
 Inventory list
 Read/Clear event log
 Parameter adjustment
 Cloning of configuration parameters
Operational parameters setting

Note: For configuring with the R&S ZS 4200, see the Service and
Maintenance Tool R&S ZS 4200 software manual.
The radio is preconfigured with the factory default settings. These settings
will be activated the first time the radio is switched on.
All radio parameters are stored in the non-volatile memory. The settings
active at the time of a power failure are restored when the radio is switched
back on.
The radio is preconfigured with the factory default settings. These settings
can be changed via service PC with the Service and Maintenance Tool
R&S ZS 4200.
The properties of the parameters can have the following status:
 A – Adjustment parameter (updated immediately after a change)
 C – Cloning parameter
 O – Operating parameter (updated immediately after a change while the
radio is in Local Mode)
For more details please refer to the Service and Maintenance Tool
R&S ZS 4200 software manual.
Value range
–30 to +10 dBm
–30 to +10 dBm
5 to 20 W
5 to 50 W
6 to 20 dB
1 to 50 µV
Disabled/Enabled
Default value
0 dBm
0 dBm
10 W
50 W
10 dB
Enabled
3.9
R&S XU 4200
Properties
A/C
A/C
A/C
A/C
A/C
5 µV A/C
C
6166.5368.02.01