Front Cabling; Fig. 2.4 Front Cabling - R&S 4200 Series Operating Manual

R&S XU 4200
2.4.2

Front Cabling

Introduction
Front Cabling\Front cabling "Radio".doc
Front cabling
(optional)
0.
6166.5368.02.01
In actual operation, the radio is usually operated via the rear panel system
interfaces, thus eliminating the need for front panel cabling. The radio is
preconfigured with the factory settings and can be operated without any
further configuration.
The front panel interfaces are needed during installation and maintenance.
The radio can be operated in the local mode via the headset. The USB
interface is used to set configuration parameters or to perform complete
software updates. Rohde & Schwarz supplies the Service and Maintenance
Tool R&S ZS 4200 for this purpose.
1.
2.
Fig. 2.4
1. Connecting the Service and Maintenance Tool R&S ZS 4200:
Software download

 Configuration
 Monitoring
2. Connecting a headset for LOCAL mode operation (voice).
Front cabling.
2.8
Basis Cabling