the EIA location directly above the lowest EIA unit used, on both the front and the rear of the rack.
Figure 19. Front of rack rail alignment and nut clip locations
4. Rotate the hinged rail latch upward to hold the rail in place against the front EIA support flange.
5. Repeat steps 1 through 5 for the left rail.
6.
Secure both rails to the front EIA support flange (B) by using two M5 x 16mm screws
7. At the rear of the rack, rotate the hinged rail latch upward to hold each rail in place against the rear
EIA support flange.
Figure 20. Rear of rack rail alignment and nut clip locations
8. Secure both rails to the rear EIA support flanges (B) by using four M5 x 16mm screws.
Installing the system into the rack by using the fixed rails and
connecting power cables
Learn how to install the system into the rack by using the fixed rails and how to connect power cables.
About this task
Note: This system requires two people to install the system into the rack.
14
Installing the System and Ordered Parts for the 8335-GCA or 8335-GTA