IBM Power System S822LC Installing The System And Ordered Parts page 24

About this task
Note: If you are installing more than one system at this time, install the cable-management arm after you
have installed the other systems into the rack.
Procedure
1. Ensure that you have the following parts.
Figure 9. Relative positions of the parts of the cable-management arm before assembly
2. Connect one end of the support arm (A) to the right slide rail (1) so that you can swing the other end
of the support arm toward the left side of the rack (2).
Note: The support arm (A) is labeled UP and DOWN. Ensure that the side labeled UP is facing
upward and to the right.
8
Installing the System and Ordered Parts for the 8335-GCA or 8335-GTA
A
Support arm
B
Cable-management stop bracket
C
Mounting bracket
D
Cable-management arm
E
Extension bracket