IBM Power System S822LC Installing The System And Ordered Parts page 55

v High performance IPV4/IPV6 checksum offload
v Supports large send and large receive
v Multiple queues
v VIOS
The following figure shows the adapter.
Figure 43. Adapter
Adapter LED states
The LEDs on the adapter provide information about the operation status of the adapter. The LEDs are
visible through the mounting bracket. Figure 43 shows the location of the LEDs. Table 8 describes the
different LED states and what those states indicate.
Table 8. Adapter LEDs and descriptions
LED
Speed
Activity/link
For details about slot priorities and placement rules, see PCIe adapter placement rules and slot priorities
(http://www.ibm.com/support/knowledgecenter/POWER8/p8eab/p8eab_mtm_pciplacement.htm) and
select the system you are working on.
Operating system or partition requirements
The adapter is supported on the following versions of the operating systems, depending on the system
you are using:
v AIX
Light
Yellow
Green
Green flashing
Off
Description
10 Mbps or 100 Mbps
1000 Mbps or 1 Gbps
Active link or data activity
No link
The absence of a link can indicate a defective cable,
defective connector, or a configuration mismatch.
Installing and configuring system features
39