IBM Power System S822LC Installing The System And Ordered Parts page 28

Figure 16. Sliding the other cable-management arm tab into the extension bracket
8. To connect the power cables, complete the following steps:
a. Plug the power cords into the power supplies.
b. Route the power cords and other cables on the cable-management arm.
c. Attach all cables to the rear of the server.
Figure 17. Rear view of the system with ports displayed
Table 1. Port callouts
Identifier
1
2
3
4
d. Plug the system power cords and the power cords for any other attached devices into the
alternating current (ac) power source.
9. Continue with "Completing server setup" on page 16.
12
Installing the System and Ordered Parts for the 8335-GCA or 8335-GTA
D
Description
USB 3.0
Ethernet
Intelligent Platform Management Interface (IPMI)
Video Graphics Array (VGA). Text based capability is
only supported at this time.
E
2