Installing And Configuring System Features; Installing A Disk Drive In The 8335-Gca Or 8335-Gta; Installing A Disk Drive In The 8335-Gca Or 8335-Gta System With The Power Turned Off - IBM Power System S822LC Installing The System And Ordered Parts

Installing and configuring system features

Learn how to install and configure customer-installable hardware features.
Before you install a feature, ensure that the software that is required to support the feature is installed on
the system. For information about software prerequisites, see the IBM Prerequisite website
(http://www-912.ibm.com/e_dir/eServerPrereq.nsf). If the required software is not installed, go to the
Fix Central website (http://www.ibm.com/support/fixcentral/) to download it, and then install it before
you continue.
Note: Installing these features is a customer task. You can complete this task yourself, or contact a service
provider to complete the task for you. You might be charged a fee by the service provider for this service.

Installing a disk drive in the 8335-GCA or 8335-GTA

®
Learn how to install a disk drive in the IBM Power System S822LC (8335-GCA and 8335-GTA) system.
Installing a disk drive in the 8335-GCA or 8335-GTA system with the
power turned off
To install a disk drive in an IBM Power System S822LC (8335-GCA and 8335-GTA) system with the
system power turned off, complete the steps in this procedure.
Installing a disk drive in the 8335-GCA or 8335-GTA system with the power turned
off
Follow these steps to install a disk drive in the IBM Power System S822LC (8335-GCA and 8335-GTA)
system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. If the slot you want to use contains a drive filler, remove the drive filler from the slot.
a. Push the lock (A) on the handle of the filler. See Figure 23 on page 18.
17
© Copyright IBM Corp. 2015, 2017