IBM Power System S822LC Installing The System And Ordered Parts page 51

Figure 39. Removing the PCIe riser
3. Place the PCIe riser on the ESD mat on the table.
4. Depending on the size of the PCIe adapter, remove one or both fillers from the carrier. See Figure 40.
Figure 40. PCIe riser with fillers installed
Option
For a single-wide adapter
For a double-wide adapter
5. If needed, label and remove any plugs that extend out of the PCIe adapter.
6. Insert the card into the PCIe riser, aligning it properly and inserting it fully into the slot. See Figure 41
on page 36.
Description
Remove the filler over the PCIe slot. For a single-wide
adapter, one of the fillers must remain in place to ensure
proper airflow and cooling.
Remove both fillers.
Installing and configuring system features
35