IBM Power System S822LC Installing The System And Ordered Parts page 89

Figure 58. Adapter
Adapter LED states
The LEDs on the adapter provide information about the operation status of the adapter. The LEDs are
visible through the mounting bracket. Figure 57 on page 70 shows the location of the LEDs. Table 15 on
page 70 describes the different LED states and what those states indicate.
Table 16. Adapter LEDs and descriptions
LED
Link/Speed
Activity
Operating system or partition requirements
This adapter is supported for the following versions of operating systems:
v Linux
– Bare Metal Systems (Not supported)
– PowerKVM 3.1 Systems or PowerKVM 2.1 (Not Supported)
– Other environments
- Red Hat Enterprise Linux 7 big-endian, or later
- Red Hat Enterprise Linux 7.1, little-endian, or later
- Red Hat Enterprise Linux 6.5 or later
- SUSE Linux Enterprise Server 12, or later
- SUSE Linux Enterprise Server 11, Service Pack 3, or later
Light
Yellow
Green
Green flashing
Off
Description
10 Mbps or 100 Mbps
1000 Mbps or 1 Gbps
Active link or data activity
No link
The absence of a link can indicate a defective cable,
defective connector, or a configuration mismatch.
Installing and configuring system features
73