IBM Power System S822LC Installing The System And Ordered Parts page 25

Figure 10. Connecting the support arm
3. Locate the hole at the bottom inside corner of the L-shaped cable-management stop bracket (B).
Position the unattached end of the support arm so that the locking tab on the underside of its tip
aligns with the bracket hole. Insert the tab into the hole (1) and turn the bracket (2) to secure it to the
support arm. For details, see Figure 11.
Figure 11. Securing the cable-management stop bracket to the support arm
4. Attach the cable-management stop bracket (B) to the slot on the inside of the left slide by sliding the
stop bracket (B) into the slide rail until the spring-loaded pin snaps into place.
Installing the IBM Power System S822LC (8335-GTA and 8335-GCA)
9