IBM Power System S822LC Installing The System And Ordered Parts page 31

Procedure
1. Remove the shipping cover on the rear and the front of the system, if present.
2. Position one person on the left side of the system and one person on the right side of the system .
3. Complete the following steps:
a. Lift the system.
b. Tilt the system into position over the fixed rack rails.
c. Carefully lower the system until the rear of the system rests on the rails.
4. While one person is supporting the weight of the system, have the second person move to the front
of the system and push the system all the way into the rack.
5. Attach the front cover to the front of the system.
Figure 21. The server installed in the rack
6. Install the screws on either side of the system to secure the system to the rack.
7. Plug the power cords into the power supplies.
8. Attach all cables to the rear of the server.
Figure 22. Rear view of the system with ports displayed
Installing the IBM Power System S822LC (8335-GTA and 8335-GCA)
15