C
3
HAPTER
5. Disconnect the 4-pin CAN connection.
6. Connect the J14 connector of the AutoBoom node harness to the rate control harness.
7. Connect the J15: CAN connector of the AutoBoom harness to the CAN terminator.
CONNECT THE HARNESS TO THE SENSORS
1. Locate the Center Sensor connector on the AutoBoom harness cable (P/N 115-0230-166).
2. Connect the Center Sensor connector to the installed center sensor (P/N 063-0130-026).
3. Locate a sensor cable (P/N 115-0230-163) and connect it to the LEFT SENSORS connector on the AutoBoom
node cable.
4. Route the cable along the left boom.
5. Connect the OUTER SENSOR connection to the outermost ultrasonic sensor.
6. If equipped, connect the INNER SENSOR connection to the inner ultrasonic sensor. If not equipped, leave the
dust cap installed.
7. Repeat step 3 to step 6 for the right side of the boom using the RIGHT SENSORS connection on the AutoBoom
node cable.
18
Case IH Patriot 2240/2250 AutoBoom™ Installation Manual