Connect The Harness To The Boom Function Controls; Connect The Harness Cable To The Sensors - Raven AutoBoom Installation Manual

Connect the Harness to the Boom Function Controls

Locate the Left Press and Right Press connectors on the AutoBoom harness cable (P/N 115-0230-045 or
1.
115-0230-085).
Route the connectors to the AutoBoom valve (P/N 063-0131-125).
2.
Connect the Left Press connector to Port G1 on the AutoBoom valve.
3.
Connect the Right Press connector to Port G4 on the AutoBoom valve.
4.
Locate the Left Solenoid and Right Solenoid connectors on the harness cable.
5.
Connect the Left Solenoid connector to Port 4A on the AutoBoom valve.
6.
Connect the Right Solenoid connector to Port 4B on the AutoBoom valve.
7.
Locate the Left Prop and Right Prop connectors on the harness cable.
8.
Connect the Left Prop connector to Port 5A on the AutoBoom valve.
9.
Connect the Right Prop connector to Port 13A on the AutoBoom valve.
10.
Machine's Left and Right Tilt Boom Function Coils
FIGURE 15.
Locate the machine boom function coils near the machine's hydraulic valve.
11.
Disconnect the connector from the machine's left tilt up coil.
12.
Install a boom sense adapter cable (P/N 115-0171-558) between the coil and the machine's coil connector.
13.
Connect the boom sense adapter cables between the left tilt down, right tilt up, and right tilt down coils and
14.
the coil connectors.
On the harness cable, locate the Left Solenoid Sense connectors.
15.
Isolate the connector labeled Up and connect it to the left tilt up coil via the installed boom sense adapter
16.
cable.
Connect the down Left Solenoid Sense connector to the left tilt down coil via the installed boom sense
17.
adapter cable.
Connect the Right Solenoid Sense connectors to the machine's right tilt up and right tilt down coils via the
18.
installed boom sense adapter cables.

Connect the Harness Cable to the Sensors

Locate the Center Sensor connector on the AutoBoom harness cable.
1.
Connect the Center Sensor connector to the installed center sensor (P/N 063-0130-018).
2.
Locate the Left Outer Sensor connector on the AutoBoom harness cable.
3.
Connect the Left Outer Sensor connector to the installed left sensor cable (P/N 115-0171-527).
4.
Manual No. 016-0230-039
UltraGlide
Boom Sense
Adapter Cables
47