Installing Discblades On New Discs - MacDon R116 Installation Instructions Manual

3.8 Installing Discblades on New Discs

Install the discblades retained from
these steps:
WARNING
Wear heavy gloves when working around or handling knives. Blades are sharp and can cause serious injury.
1. Place a pin (or equivalent) in the front hole of the rock
guard to prevent disc rotation while tightening blade bolts.
2. Install blade (A) with shoulder bolt (B) onto disc (C). Blade
and bolt are retained from
Attachment Hardware, page
3. Install nut (D) and torque to 125 Nm (92 lbf·ft).
IMPORTANT:
Nuts are one-time use only. When flipping or changing a
blade, replace using a NEW nut only.
WARNING
Ensure cutterbar is completely clear of foreign objects. Foreign objects can be ejected with considerable force when the
machine is started, and may result in serious injury or machine damage.
214913
INSTALLATION INSTRUCTIONS
3.3 Removing Discblades and Attachment Hardware, page 12
3.3 Removing Discblades and
12.
A
Figure 3.28: Discblade
22
on the new discs. Follow
D
B
C
Revision B