Removing Left Inboard Drum, Disc, And Driveline - MacDon R116 Installation Instructions Manual

3.6 Removing Left Inboard Drum, Disc, and Driveline

To remove the inboard drum on the left side of the cutterbar and the associated cutterbar disc and driveline, follow
these steps:
WARNING
Wear heavy gloves when working around or handling knives. Blades are sharp and can cause serious injury.
1. Remove four M10 hex flange head bolts (A) and remove
vertical driveshield (B).
2. Remove two M10 hex flange head bolts (A) and remove
cover plate (B).
3. Remove four M10 hex flange head bolts (A), and remove
top plate (B) and drum top (C).
214913
INSTALLATION INSTRUCTIONS
Figure 3.11: Vertical Drive Shield
Figure 3.12: Cover Plate
Figure 3.13: Top Plate and Drum Top
15
B
A
B
A
B
A
C
Revision B