Chapter 3: Installation Instructions; Opening Cutterbar Doors - North America - MacDon R116 Installation Instructions Manual

Chapter 3: Installation Instructions

To install the Small Drum kit (MD #259140), follow these procedures in order:
3.1 Opening Cutterbar Doors – North America
If the pull-type was sold outside of North America, it will have export latches. Refer to
Export Latches, page 10.
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key from ignition
before leaving operator's seat for any reason.
1. Center the pull-type beneath the hitch, if both doors need
to be opened.
2. Shut down the engine, and remove the key from the
ignition.
3. Lift up on door (A) at the front to open.
214913
3.2 Opening Cutterbar Doors –
A
Figure 3.1: Cutterbar Doors and Curtains – Pull-Type
9
Revision B