MacDon R116 Installation Instructions Manual page 25

6. Lubricate spindle splines (A). For specifications, refer to the
pull-type technical manual.
NOTE:
For clarity, illustration shows cutaway view of drum and
tube shield.
7. Insert driveline (B) (MD #259139) at an angle and guide it
past hub drive (C) and drum (D).
NOTE:
Driveline (B) is considered maintenance-free (lubed for life),
but if desired, you can grease the driveline U-joints before
installing.
8. Insert splined spindle end (A) into splined bore of
driveline (B).
9. Place a bead of medium-strength threadlocker
®
(Loctite 243 or equivalent) around threads, and install four
M12 hex flange head bolts (A) and spacers to secure
driveline assembly (B) to hub drive (C). The bolts and
spacers were retained from the removal procedure.
10. Torque bolts to 102 Nm (75 lbf·ft).
11. Position two drum shields (B) (MD #281497) on top of the
clockwise drum assembly as shown. Apply a bead of
medium-strength threadlocker (Loctite
around threads, and use eight M8 hex flange head bolts (A)
(MD #136485) to secure the drum shields in place.
12. Torque to 27 Nm (20 lbf·ft).
214913
INSTALLATION INSTRUCTIONS
Figure 3.21: Driveline
Figure 3.22: Driveline Installed
®
243 or equivalent)
Figure 3.23: Drum Shields Installed
19
D
A
B B
C
B
A
C
A
B
A
Revision B