Installing New Left Drum Assembly, Shields, And Driveline - MacDon R116 Installation Instructions Manual

3.7 Installing New Left Drum Assembly, Shields, and Driveline

To install the new clockwise drum assembly, shields, and driveline provided in the kit, follow these steps:
WARNING
Wear heavy gloves when working around or handling knives. Blades are sharp and can cause serious injury.
NOTE:
Unless otherwise stated, all parts are provided in the kit.
1. Remove the remaining parts from the kit.
2. Ensure spacer (A) is on spindle.
3. Position the new clockwise drum assembly (MD #257085)
over the exposed spindle. The disc must be positioned at a
90-degree angle relative to neighboring discs.
4. Use an 18 mm deep socket to install four M12 bolts (A)
(MD #281697) and washers (MD #246952), securing the
drum assembly to the spindle.
5. Torque to 85 Nm (63 lbf·ft).
214913
INSTALLATION INSTRUCTIONS
Figure 3.19: Clockwise Spindle
Figure 3.20: New Clockwise Drum Assembly
Positioned on Spindle
18
A
A
1026166
Revision B