MacDon R116 Installation Instructions Manual page 27

17. Apply a bead of medium-strength threadlocker
®
(Loctite 243 or equivalent) around threads, and then
install top M10 hex flange head bolt (B) (MD #152655)
through cover plate (A) (MD #281500) and back plate (C).
18. Apply a bead of medium-strength threadlocker
®
(Loctite 243 or equivalent) around threads, and then
install lower M10 hex flange head bolt (D) (MD #152655)
through cover plate (A) and vertical shield (E).
19. Torque bolts (B) and (D) to 61 Nm (45 lbf·ft).
20. Position plate shield (B) (MD #281501) as shown at right.
Apply a bead of medium-strength threadlocker
®
(Loctite 243 or equivalent) around threads, and then use
four M10 hex flange head bolts (A) (MD #152655) to secure
the plate shield in place.
21. Torque to 61 Nm (45 lbf·ft).
214913
INSTALLATION INSTRUCTIONS
Figure 3.26: Installing Cover Plate
Figure 3.27: Plate Shield Installed
21
C
E
A A A A
B
D
A
B
Revision B